* Please use the "Backing up all data" function. (Refer to the Owner's Manual P.56).
* Never power-off your SPD-30 while the update is in progress. If a power failure or similar accident occurs during the update process, the SPD-30 won’t be able to start up in normal operating mode.
- Start your computer then connect the USB memory to a USB connector of the computer.
* Please use a USB memory formatted by using your SPD-30. ( Refer to the Owner's Manual P.55 )
- Copy the update file "spd30.bin" and "spd30_prog1.bin" onto the root directory of the USB-memory device.
* Do not copy the "spd30_sys_v204" folder.
- Un-mount the USB-memory device through the correct procedure, then disconnect from the computer.
- Connect the USB-memory device to SPD-30 with the power turned off.
- Turn SPD-30 power on with pushing the [ F3 ] button. The following screen appears.
Updater
App Ver.(Build):
2.03(101) -> 2.04(103)
[Mass Production ]
Press 'F1' to execute.
[F1]
- Push the [ F1 ] button. Update process starts.
About twenty seconds later, "completed" will be displayed.
Updater
App Ver.(Build):
2.04(103)
[Mass Production ]
>execute .....
completed!
Turn the power off.
Switch on the POWER again,
and execute a FACTORY RESE
T.
- Turn the power off and on again.
- When it was updated from Version 1.xx, "All kit data was reset to the new factory preset data." automatically as the message appearing on the screen on booting up.
- Perform the Factory Reset operation. (Refer to the Owner's Manual P.20)
- Please load your backup data if needed.
* After you perform the update, you must delete the update file from the USB-memory device for the normal usage.
* Please use "Loading all data" function to re-load the backup data if you backup( Refer to the Owner's Manual P.57 ).