VS-1680, VS-1880, VS-1824: Routing an input to any track?

Tags: input,vs-1680,vs-1824,vs-1880,track,routing,recording,ez,status,arming
You can route any input to any track you want to record on using the following steps. In short, you hold down the Status button for the track you want to record onto, and keep the button depressed for the next few steps, clear the previous routing, and press the INPUT SELECT button for the INPUT you wish to use. Be sure to link inputs or tracks as desired.
Step by Step:

1- Make sure that the TR (TRACK FADER) mode indicator is
2- Hold down the STATUS button for the TRACK you want to
the next few steps.) The INPUT ASSIGN screen will
appear as you hold down the button.

3- You may want to press the CLEAR button to clear any
previous routing depending on your application.

4- Press the INPUT SELECT button for the INPUT you wish to
use. The INPUT SELECT buttons are the top row of
buttons above the faders. The Screen will show a line
drawn from the TOP of the screen (INPUT CHANNEL) to the
middle row of numbers which are the RECORDING TRACKS.

5- You can now release the STATUS button, set the input
levels and arm the track for recording.

If you want to make additional routings, continue repeating all steps above except for STEP-2 which is to clear all routing.

To unselect a routing, you would do the same steps above by holding the STATUS button for the track you are routing to, and then press the Input select button again which toggles between being routed and un-routed.