ME-20: Selecting Patches
Patches are stored in the ME-20 in ten banks, numbered from 1 to 10. Each bank holds three patches. To load a patch, you first select the bank that contains the patch, and then you select the patch. Use the following procedure to load Patch 5-3 (Bank 5, Patch 3) as an example:
Press Pedals 2 and 3 simultaneously to enter Memory mode where the current Bank number shows in the display and the displays MEMORY indicator lights.
Press the BANK Up or Down button so the number 5 flashes in the display. This tells you that Bank 5 is selected and that the ME-20 is waiting for you to choose the desired patch in Bank 5.
Now step on Pedal 3 the 5 stops flashing and Patch 5-3 is loaded.
Using the same procedure, try out some of the other patches in the ME-20.
Tip: You can also select different banks using Pedals 2 and 3. To do so, press and hold Pedal 2 for two seconds until the pedal indicators are flashing, and then press Pedal 1 or 2 to select a desired bank. Once youve chosen the bank, press Pedal 3, and then press one of the three pedals to select the desired patch.