SI-24 Not Communicating with Logic RPC Pro

Tags: control,logic,studio,package,rpc,pro,si-24,scan,fader,rpc-si24,transport

If the SI-24 is not communicating with the Logic RPC Pro software, try these troubleshooting procedures:

1. On the SI-24, hold SYSTEM and press L5.

2. In the Logic RPC Pro software, go to the Options menu and select Control Surfaces > Scan.

If the SI-24 still won't communicate with Logic RPC Pro, continue with the following procedure:

3. Power the SI-24 off.

4. Hold CH SELECT 2 and STATUS 2 while powering the unit on.

5. Power the SI-24 off, then on again.

6. Repeat steps 1 and 2 above.