TD-10: Footswitch Operation

Tags: td-10
Two BOSS FS-5U footswitches and a commonly available TRS "insert cable" can be
used to control the TD-10. Use the following procedure to set the footswitch
mode:

1) Connect the foot switches and insert cable to the FOOT SWITCH jack.
2) Press SETUP.
3) Press F3 "CTRL."
4) Press F1 "FOOT SWITCH."
3) Use [INC/DEC] or the VALUE dial to select the MODE (see list below.)
4) Press [EXIT] to leave this page.

MODE SW1 SW2
KIT SELECT Select the previous kit Select the next
kit
PATTERN SEL Select the previous pattern Select the next
pattern
PATTERN PLAY Select the next pattern Playback/ stop the
pattern