TD-6, TD-6V: Not able to get Dual Trigger Response from the Snare when using a Roland Mesh Pad:

Tags: td-6,td-6v
If you're unable to get dual trigger response from your snare mesh pad, it would be most likely due to an improper "Trigger Type" setting in the TD-6/V. To set the trigger type for the snare pad, use the following steps:

Note: First confirm that an appropriate dual trigger cable is being used for the pad, and it's connected correctly to the TD-6/V.

1. Hold SHIFT and press EDIT/SETUP.

2. Press the right CURSOR to select "TRIG BASIC."

3. Press ENTER.

4. Hit the Snare Pad.
Note: If "NOTE CHASE" is set to "Off" in the TD-6, hitting each pad will not change the trigger input number in the display. You can select a trigger input without hitting a pad by holding SHIFT and pressing the Left(<) or Right(>) CURSOR buttons.

5. Press the INC (+) or DEC (-) buttons to select the appropriate Trigger Type:
For a PD-80R, PD-85, or PDX-8 choose "PD-80R".
For a PD-120, choose "PD-120".
PD-105 or PD-125 choose "PD-125".

6. Press EXIT when you're finished. The settings are stored automatically.