SE-50: Writing a Patch into Memory

Tags: se-50
The SE-50 allows you to edit a patch and then store it into memory for future
use. Use the following procedure to write a Patch into memory:

1) Press WRITE, the Patch number will begin to flash.
2) Use the NUMBER UP and DOWN buttons to select a memory location between 1
and 100.

Note: Patch 101 through 128 are in permanent ROM memory and cannot be changed.

3) Press WRITE again and your Patch will be stored into memory.

Note: This procedure will erase a preexisting Patch, be sure to select a memory
location of a Patch that is not being used.