RD-700GXF: Assigning the Sustain Pedal to Parts in a Layer or Split

Tags: split,layer,rd-700gxf,parts,sustain pedal

The RD-700GXF allows you to use up to 4 sounds at a time in a Layer or a Split . Depending on the sounds you select, you may want the sustain pedal to control only certain sounds. For example, in a bass and piano split, it's nice to sustain the piano sound but not the bass. Use the following procedure to enable or disable the sustain pedal in the parts of a Layer or a Split. 

1. After creating a SPLIT or LAYER, press the ZONE INFO button so it is flashing.

2. Use the UP / DOWN CURSOR buttons to select the part you wish to edit.

3. Use the LEFT / RIGHT CURSOR buttons to highlight the "Dp" column.

4. Use the INC / DEC buttons to either remove or put a check mark in the box for the selected part.

NOTE: The presence of a check means that the selected part WILL be affected by the use of the sustain (damper) pedal.

NOTE: If you wish to save your settings, be sure to save them to a new USER SET UP.