FR-7xb: Copying an FR-7xb Register from One SET into another SET

Tags: fr-7xb
Use the following procedure to copy a Register from one Set into another Set on your FR-7xb:

1. Select the source SET and REGISTER that you wish to copy.

2. Press and hold the MENU/WRITE button to display the "WRITE" menu.

3. Rotate the DATA knob to select "ALL PARAM" and press ENTER.

4. Rotate the DATA knob to remove the "check mark" from the "ALL PARAM" check box and press ENTER.

5. Rotate the DATA knob to select the "Set" check box and press ENTER.

NOTE: "Set" is located below "MIDI" and above "Common."

6. Rotate the DATA knob to place a check mark in the check box and press ENTER.

7. Rotate the DATA knob counterclockwise to place the cursor under the word "to" and press ENTER.

8. Rotate the DATA knob to select the target or destination set that you wish to copy the register to and press ENTER.

9. Rotate the DATA knob clockwise to highlight and select any register category and register number that you wish to copy.

NOTE: By default, ALL categories and ALL register numbers are pre-selected.

10. When you have finished making your selections, press the WRITE button to display "Executing do not power off" while your settings are being copied to their new location.