VS-2400CD, VS-2400: Erasing a Track

Tags: track,erase,remove,delete,region,cut

The following article will guide you through erase all of, or a portion of, a track.

If you are using the installed LCD screen:

  1. Press and hold SHIFT and then press F2 (TRACK).
  2. Press F6 until "Reg->Ph" appears above F6.
  3. Press F5 (ERASE) and then press ENTER. The track STATUS buttons will begin to blink green.
  4. The STATUS button of the track(s) that you would like to erase. A selected track's STATUS button will turn solid red.
  5. Use the ZOOM cursor buttons and the TIME/VALUE dial to set the IN and OUT points.
    Edit Points:
    IN - sets the beginning of the audio segment you’re erasing.
    OUT - sets the end of the audio segment you’re erasing.

    NOTE: If you would like to erase the entire track, set the following:
    IN - 00:00:00.00-00
    OUT - set this to the end of recording.
  6. Press F5 (OK) and then ENTER.

 

If you are using an external VGA monitor:

  1. Click on TRACK on the top of the screen and then select REGION ERASE. The track STATUS buttons will begin to blink green.
  2. The STATUS button of the track(s) that you would like to erase. A selected track's STATUS button will turn solid red.
  3. Use the mouse and the TIME/VALUE dial to set the IN and OUT points.
    Edit Points:
    IN—sets the beginning of the audio segment you’re erasing.
    OUT—sets the end of the audio segment you’re erasing.

    NOTE: If you would like to erase the entire track, set the following:
    IN - 00:00:00.00-00
    OUT - set this to the end of recording.
  4. Press F5 (OK) and then ENTER.