CDX-1: How Do I Set my Start and End Points for a Sample Loop?

Tags: loop,editing,sample,point,cdx-1,end,start
To get a sample to loop seamlessly, it is neccesary to dial in precise start and end points for the loop. To set these points use the following procedure:

1) Press PAD EDIT/TEMPO MATCH
2) CURSOR to PARAM
3) Press YES/ENTER
4) Use the TIME/VALUE wheel to select GATE for "Pad Play"
5) Highlight "Loop Mode" then use the TIME/VALUE wheel to select "START-END"
6)CURSOR to "Start Point"
7)As you press the sample pad, adjust the start time by using the TIME/VALUE wheel.

Note: Each time that you press the pad it will restart the sample. Ideally you will want adjust the start time so that it triggers immediately when you press the pad.


8) To adjust the end point CURSOR to "Length End" and use the TIME/VALUE wheel to adjust the end point.