TD-8

Percussion Sound Module

Listing items from 1 to 17 of 17 results.

Q.What are the suggested drum playing techniques and available functions for each TD-series sound module?

A.

The following table shows the suggested drum playing ・・・

Q.When I strike the center of the head, I sometimes hear the rim-shot sound also.

A.

This phenomenon may occur when the cable plugs are not fully ・・・

Q.When I perform a cymbal choke operation on a pad, can I simultaneously send a MIDI message from a TD-series module’s MIDI OUT jack to an external MIDI device?

A.

Yes. Choke operations are transmitted from the TD-series ・・・

Q.Can I re-arrange the order of the drum kits ?

A.

Yes, you can step through the drum kits of your choice in the ・・・

Q.Occasionally, I hear a cymbal sound that seems to be generated for no reason. Why does this occur ?

A.

This problem is very rare. Make sure that the AC source is ・・・

Q.If the TD series modules are synchronized through MIDI, can the metronome click be assigned to come out the phones output only ?

A.

It is possible with the TD-10 and TD-8. ・・・

Q.Can I play the V-drums with my acoustic drum set using acoustic drum triggers ?

A.

Yes, it is possible. In the TMC-6, TD-10, and TD-8, change the ・・・

Q.Can I use a V-cymbal with a TD-8 that is at a software version earlier than 1.10? Also, can I use a V-Cymbal with older TD-series models or an SPD-series unit?

A.

Yes. You can use a V-Cymbal with the TD-8 (any software ・・・

Q.What is the maximum storage capacity of the sequencer of the TD-10/8/6 ?

A.

Approx. 4,000 notes for the TD-10, approx. 14,000 notes for ・・・

Q.The sound does not change regardless of where the pad is struck. (No response to positional sensing).

A.

Position sensing is only available from the SNARE input on the ・・・

Q.I could not get the correct sound when striking the edge of the V-cymbal while connected to the TD-8 or the TD-10 without the TDW-1. What should I do ?

A.

You should assign the appropriate sound for the edge ・・・

Q.When adjusting the pitch of an instrument on a TD-6-series or TD-8 sound module, the pitch value can be adjusted over a range of -480 to +480. What value should I use to raise (or lower) the pitch by a semitone?

A.

When adjusting an instrument's pitch on a TD-6-series or TD-8 ・・・

Q.When I strike a pad, a pattern starts playing. How can I stop this from happening?

A.

The Pad Pattern function allows you to start playback of a ・・・

Q.When a CY-12R/C or CY-15R is connected to a TD-series sound module, is three-way (separate) triggering of bow, bell, and edge shots available?

A.

Three-way triggering is only possible when the CY-12R/C or ・・・

Q.Can you show me the pads that are compatible with the TD-series and other sound modules? (2004 Version which excludes the TD-12 and VH-11)

A.

You can see compatibility details in the Compatibility table ・・・

Q.I can't play open/closed hi-hat techniques with my TD-series sound module. Why is this?

A.

This situation can occur if the hi-hat control pedal (FD-7, ・・・

Q.Can I make a pattern start playing by striking a pad?

A.

Yes, you can. To play back your favorite pattern by ・・・

To the top of page