R-26

Q.Which brands of Power Supplies are compatible with the R-26?

A.Compatible Power Supplies

The following Power Supplies have been verified to work properly on the R-26.

Manufacturer name	Model name	Time for continuous recording	Final voltage(*1)
IDX	E-10S (*2)	39 hours	12.0V
IDX	NP-L7S (*2)	32 hours	12.0V
IDX	XL-70	40 hours	11.0V

[The setting values on the measurement]

• REC MODE:6 CHANNEL
• REC SOURCE: XY+ANALOG+P-IN
• INPUT1 PHANTOM: ON(* 3)
• INPUT2 PHANTOM: ON(* 3)
• PLUG-IN POWER: ON

(Parameters other than the above list was set to the default value.)

* 1:	You can select the final voltage of an external power supply on the [MENU]→[SYSTEM SETUP]→[EXT-POWER]. (Please refer to the "Using External Power Sources" section(P.23) of the owner's manual for details.)
* 2:	An additional attachment is required for connecting to the R-26.
* 3:	On using 10mA in total of 2-channel for the phantom power supply.

CAUTION：

*	Please take the above table only as a guide. It does not provide any guarantees of actual time for continuous recording.
*	These figures will vary depending on the specifications, the charging conditions, the drain levels of the batteries and the actual conditions of use.
*	Refer to the user's manual for the external power source and be sure to set the final voltage for the R-26 when using an external power source. If the final voltage is not properly set for the external power source, the remaining power display cannot be shown. In some cases, a battery would burn power faster than usual or fall into disrepair.
*	Some power supplies bearing model numbers included in this list may not be usable due to differences in design specifications and usage environment. The inclusion of a model number on this list is not a guarantee that all power supplies bearing that number will be fully usable.

(2011/09/08)

Go back to the list