VC-30HD

Video Converter

System ProgramVC-30HD Ver.1.021 System Program

This is the software to make your VC-30HD up-to-date.

Products:VC-30HD



How to tell the version
Please check the version of the system working on your VC-30HD before downloading the archive file.
 
Procedure which used the VC-30HD RCS
Run the VC-30HD RCS and then connect your VC-30HD to your computer. The version number of the VC-30HD is displayed in the "Signal Display Section" of the VC-30HD RCS.
 
Procedure which does not use the VC-30HD RCS
  1. Immediately after sliding the [POWER] switch to [ON] position , long-push the [VIDEO INPUT] and the [OUTPUT FORMAT] buttons both within a few seconds.
    Keep pushing the buttons until all the indicators blink except the "SENS" indicators.
  2. When they did so, connect VC-30HD to your Windows computer via USB.
  3. The drive named as "VC-30HDxxxx" appears on your computer. The "xxxx" indicates the version number.
    (If it is "Ver.1.010", the drive name will be the "VC-30HD1010")
  4. Turn off VC-30HD to end the version check.
 
* Don't perform the update if the product is already up-to-date.


[ Ver.1.021 ]
Function Improvements
  • In addition to the i.LINK connector and the USB connector on the rear panel, Video signal can be output from the i.LINK connector on the front panel simultaneously.


Items to prepare for the update
Following items are required to perform the update.
  • VC-30HD itself
  • USB Cable
  • Windows computer
    * Apple Macintosh cannot be used for updating.


How to download and expand the archive file
Download the file named "vc30hd_sys_v1021.zip".
It is an archive file in zip format, please double click on the file to expand. After expanding the file, the folder "vc30hd_sys_v1021" holding the file "VC-30HD1021.PRG" will be appeared.


How to update
Please install the system program " VC-30HD1021.PRG" to the VC-30HD by following the process below.
Important notice: Never turn the VC-30HD off during the update process, or VC-30HD won't reboot correctly any more.

  1. Immediately after sliding the [POWER] switch to [ON] position , long-push the [VIDEO INPUT] and the [OUTPUT FORMAT] buttons both within a few seconds.
    Keep pushing the buttons until all the indicators blink except the "SENS" indicators.
  2. When they did so, connect VC-30HD to your Windows computer via USB.
  3. The drive named as "VC-30HDxxxx" appears on your computer. The "xxxx" indicates the version number.
    (If it is "Ver.1.010", the drive name will be the "VC-30HD1010")
  4. Open the "VC-30HDxxxx" drive in the "My Computer" (or "Computer") on the Explorer.
  5. Copy (drag and drop) the "VC-30HD1021.PRG" in the "vc30hd_sys_v1021" folder to the root directory in the "VC-30HDxxxx" drive.
  6. When the copy processing is completed, un-mount the USB drive on your computer.
  7. Turn off VC-30HD to complete the update procedure.
  8. Refer to the "How to tell the version" section of this document to verify that the version number has been updated to this version.



License Agreement

Be sure to read the Safety Instructions and the License Agreement before proceeding download.

Download file

To the top of page