TD-30K

V-Drums V-Pro Series

DriversTD-30 Driver Ver.1.0.0 for Windows 7 / Vista / XP

This is a driver for using the TD-30(Ver.1.10 or later) on Microsoft Windows 7 / Vista / XP.
If your TD-30 is Ver.1.01, please use the driver included in the accessory CD-ROM.

Products:TD-30 / TD-30K / TD-30KV



Important Nortice
The "TD-30 Driver Ver.1.00" requires that your TD-30 has been updated to the Version 1.10 or later.


Uninstall the TD-30 USB MIDI Driver
If you install the TD-30 USB MIDI Driver to your computer, uninstall it.

  1. Start up Windows with all USB cables disconnected.
    (except for keyboard and mouse)
  2. Exit all applications before you begin the uninstallation.
  3. Open "Control Panel" and click "Add or Remove Programs."
  4. In the list, choose "TD-30 USB MIDI Driver", and click "Change/Remove."
  5. The display will indicate "The installed TD-30 USB MIDI Driver will be uninstalled." and click the [ OK ].
    * If any other message appears, follow the directions of the message.
  6. When the message "Uninstallation was completed." is displayed, click [ OK ] to restart Windows.


System requirements
This driver has the following requirements.

Operating System
Microsoft(R) Windows(R) 7 32-bit Edition (Service Pack 1 or later)
Microsoft(R) Windows(R) 7 64-bit Edition (Service Pack 1 or later)
Microsoft(R) Windows Vista(R) 32-bit Edition (Service Pack 2 or later)
Microsoft(R) Windows Vista(R) 64-bit Edition (Service Pack 2 or later)
Microsoft(R) Windows(R) XP Home Edition (Service Pack 3 or later)
Microsoft(R) Windows(R) XP Professional (Service Pack 3 or later)
 
Computer
Windows-compatible PC equipped with USB 2.0 port

* Intel chipset recommended.
* TD-30 may not perform to its full specs when used with an added USB 2.0 interface card.
* This product cannot be used with a USB 3.0 port that is not compatible with USB 2.0 specification.
* If this product does not work correctly when connected to a USB 3.0 port, you will need to connect it to a USB 2.0 port.
* Even if connected to a USB 3.0 port, this product will operate as a USB 2.0 device; the performance of the product will not change.
* This driver cannot be used in a virtual Windows environment, such as Windows XP Mode (Virtual Windows XP) or Virtual PC.
* Macintosh computers running Microsoft Windows are not supported.
 

  • Microsoft, Windows and Windows Vista are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.
  • ASIO is a trademark of Steinberg Media Technologies GmbH.
  • All product names mentioned in this document are trademarks or registered trademarks of their respective owners.

License Agreement

Be sure to read the Safety Instructions and the License Agreement before proceeding download.

Download file

To the top of page