SPD-SX

Sampling Pad

UtilitiesSPD-SX factory settings file

Includes the factory settings file that contains all wave and kit data.

Products:SPD-SX



What you will need to recover your SPD-SX
  • SPD-SX
  • PC to write the files to the USB flash drive
  • USB flash drive ( Roland's M-UF2G is recommended )
    * It needs to be formatted with MS-DOS file system (FAT or FAT32) on a PC.


Getting the recover files
Please open/extract the downloaded "spdsx_fact_data.zip" file on your computer to get the factory settings file in the "spdsx_fact_data" folder.


Restoring All the Factory Default Settings
[CAUTION]
* When you execute the procedures of this "Restoring All the Factory Default Settings" section, all data in your SPD-SX will be overwritten. If it contains important data that you want to keep, save it to a USB flash drive before you proceed.

Creating the USB memory for update
  1. Connect the USB memory to the USB connector of your computer.
  2. Copy the extracted "Roland" folder in the above to the root folder of the USB memory.
    * Copy not each content in the "Roland" folder, but the entire folder.
  3. Disconnect the USB memory from your computer as follows.

    [ Windows ]
    Use the Safely Remove Hardware icon in the Windows task tray to un-mount the USB memory. And then disconnect the USB memory from your computer.

    [ Mac ]
    Drag the Drive icon of the USB memory into the trash in the dock. And then remove the USB memory from your computer.
Loading wave and kit data from a USB Flash Drive
  1. Connect your USB flash drive to the USB MEMORY connector.
  2. Choose [MENU] -> [UTILITY] -> [LOAD (USB MEM)].
    The LOAD (USB MEMORY) screen will appear.
  3. Use the cursor buttons to select "ALL," and then press the [ENTER] button.
  4. Use the cursor buttons to select "Factory_V101," and then press the [ENTER] button.
    A confirmation message will appear.
    If you decide to cancel without executing, press the [EXIT] button.
  5. Press the [ENTER] button.
    The data will be loaded.
Initializing the SYSTEM parameters of SPD-SX to the factory settings (SYSTEM INIT)
  1. Choose [MENU] -> [SYSTEM].
    The SYSTEM screen will appear.
  2. Choose [QUICK MENU] -> [SYSTEM INIT], and then press the [ENTER] button.
    A confirmation message will appear.
    If you decide to cancel without executing, press the [EXIT] button.
  3. Press the [ENTER] button.
    The SYSTEM parameters will be initialized.
Initializing the SETUP parameters of SPD-SX to the factory settings (SETUP INIT)
  1. Choose [MENU] -> [SETUP].
    The SYSTEM screen will appear.
  2. Choose [QUICK MENU] -> [SETUP INIT], and then press the [ENTER] button.
    A confirmation message will appear.
    If you decide to cancel without executing, press the [EXIT] button.
  3. Press the [ENTER] button.
    The SETUP parameters will be initialized.


License Agreement

Be sure to read the Safety Instructions and the License Agreement before proceeding download.

Download file

To the top of page