RC-300

Loop Station

DriversRC-300 Driver Ver.1.0.1 for Windows 8 / 8.1

This is the RC-300 driver for Microsoft(R) Windows(R) 8 / 8.1 64-bit Edition / 32-bit Edition.

Products:RC-300



Important Nortice
The "RC-300 Driver Ver.1.0.1 for Windows 8 / 8.1" requires that your RC-300 has been updated to the Version 1.03 or later.



To use this driver, you must set the USB Mode of the RC-300 to "AUDIO."

Software Installation
[ When the message about Windows SmartScreen is displayed ]
When the message about Windows SmartScreen is displayed on installing or executing a software, please perform the following procedures.
  1. Click the [ More info ].
  2. Click the [ Run anyway ].
* If your PC does not be connected to the Internet, Step.1 will be skipped.

System requirements
This driver has the following requirements.

Operating System
Microsoft(R) Windows(R) 8 / 8.1 ( 64-bit Edition / 32-bit Edition )
* This driver will not work on Windows RT.
Computer
Windows-compatible PC equipped with USB port
* It works incorrectly when connected to a USB 3.0 port.

* This driver cannot be used in a virtual Windows environment, such as Hyper-V or Virtual PC.
* Mac computers running Microsoft Windows are not supported.


* Microsoft and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.
* All product names mentioned in this document are trademarks or registered trademarks of their respective owners.


License Agreement

Be sure to read the Safety Instructions and the License Agreement before proceeding download.

Download file

To the top of page