R-88

- Nominal voltage: 9 - 16V
- Maximum discharge current: 2A or more
- Cutoff voltage: 9 - 12V

CAUTION :
* When the voltage level input to R-88 exceeds 18V, the protection circuit turns the power off.
* Refer to the user's manual for the external power supply and be sure to set the final voltage for the R-88 when using an external power supply. If the final voltage is not properly set for the external power supply, the remaining power display cannot be shown. In some cases, a battery would burn power faster than usual or fall into disrepair.
* An additional attachment is required for connecting to the R-88.
* You can select the final voltage of an external power supply on the [ MENU ] - [ SYSTEM SETUP ] - [ EXT-POWER ]. (Please refer to the "Using External Power Sources" section of the owner's manual for details.)

[ The setting values on the measurement ]
INPUT SW : IN 1 to 8
SAMPLE RATE : 96 kHz
BIT DEPTH : 24 bit
PHANTOM SW : IN 1 to 8 ON ( Total current of all channels: 40mA )
PHONES : 10 mW
OUTPUT : OUT 1 to 2 MIX、OUT 3 to 8 OFF
BACKLIGHT : 2
DISPLAY TIMER : 5 sec
BUTTON LIGHT : DIM

CAUTION :
* Please take the above table only as a guide. It does not provide any guarantees of actual time for continuous recording.
* These figures will vary depending on the specifications, the charging conditions, the drain levels of the batteries and the actual conditions of use.
* Some power supplies bearing model numbers included in this list may not be usable due to differences in design specifications and usage environment. The inclusion of a model number on this list is not a guarantee that all power supplies bearing that number will be fully usable.